|
|
|
USAGE INSTRUCTIONS |
|
1. Slide bottle into the metal basket
at the bottom of the Fluid Filler until it
clicks in place. Remove the cap. (it may take some effort as the fit is tight) |
|
2. Lower the Fluid Filler into the water
to be tested about 1.5 feet down,
holding just the main handle. (Chlorine at the surface of the water
has been broken down by the sun and will not reveal accurate water
chemistry) |
|
3. Lift the inner handle up an inch
or two with one finger and the water will flow
into the bottle. It takes 7-8 seconds to fully fill the bottle. If you are only
going to
fill a test kit, allow the bottle to fill for 3 seconds. |
|
4. To retract from pool, release the inner
handle, lift up the tool by the main
handle and remove. |
|
5. Place the cap on bottle and remove
the bottle by pulling up and away from the
Fluid Filler. (Again this will take a little effort) |
|
|
|
Fluid Filler STORAGE INSTRUCTIONS |
|
Remove
the bottle and keep it indoors between testing. Hang the Fluid
Filler on a nail or hook in a shaded area away from direct sunlight.The
Fluid Filler is designed to give you years and years of faithful
service. Keeping it out of direct sunlight and storing the plastic
bottle indoors between testing will keep the Fluid Filler functioning
great. You can use any 8 oz. plastic, 2 inch round, cylindrical
bottle. |
|
|
DO NOT USE A GLASS BOTTLE
|
|
|
|
|
|
|
|
|